Instructions

* Warning *

PLEASE READ THESE INSTRUCTIONS CAREFULLY PRIOR TO USE.

IMPROPER USE COULD LEAD TO INJURY.

How to use:

  1. Set your desired tee height by sliding the rubber grommet up or down the tee.                                                   --See note below for tightening grommet--
  2. Pull approximately 1 foot of line out of the Tee Retriever.   NOTE : Do not over extend the line from the reel. By doing so the reel may be damaged.
  3. Hold the ball on top of the Tee, then gently swing the Retriever away from you - laying it on the ground... Stretch the line back to you and push the tee into the ground until the rubber grommet stops at your desired tee height.    [Note: for USGA events always check rules - you cannot use any tool to aid alignment]
  4. After the shot - pick up the Retriever in one hand while holding the Tee securely in the other... push the button to slowly return the Tee back to its holder.

*Caution!*

The Retriever reel has a strong return spring - Pushing the return button with one hand, and NOT holding the Tee with the other, could result in injury*

Works with Virtually Any Tee

For Changing Tees or Adjusting Tee Height

Note: When changing tees, needing to tighten the grommet, or adjusting tee height, move the grommet to your desired position on the tee.  Then holding the tee with one hand, pull the string back and forth with the other hand a few times to tighten the self-locking knot on the grommet.